500A Battery Start Fire Line Car Battery Jumper Terminal Block Car Power Connection Wire Clip

First, the connection procedure is as follows: 1 First clamp the red wire of the start line above the positive pole of the red battery of the "rescue car". 2Then clamp the red wire at the other end over the positive pole of the red battery of the "rescue car". 3 Clamp the black wire to the black negative battery of the "rescued car". 4Then clamp the black wire to the black negative battery of the "rescue car". 5 Start the engine of the "rescue car" first, and then start the engine of the "rescue car". If you find that the rescued car is still unable to start, Please check if the metal contact part is in poor contact. Note: After starting the engine, you still need to remove the startup line in order, otherwise it may cause a short circuit. Second, the procedures for removing the wires are as follows: 1First remove the "rescue car" black wire. 2We remove black wire of "rescue car" again. 3 Then remove the red wire of the "rescue car". 4 Finally, the red wire of the "rescue car" is removed. This 500A battery line is for export packaging. Precautions: 1. When the car is unable to start without power, it can be started by the battery of another vehicle. Bold battery start line, The maximum passing current is 500 AMP, which is generally suitable for gasoline engines with a displacement of less than 2500 cc or a displacement of less than 2000 cc. Used between diesel engine batteries. 2. The two cars cannot have any contact. The electronic systems of the two cars must have the same voltage. If the battery is frozen, please do not Use this launch line. 3. Before connecting, the engine, sound and air conditioner of the two cars need to be turned off.